- 43
- 11
Lol, no kidding, I already knew that, but these were given to me, so I figured I would do something with them! U have any ideas on that lace accent?
Thanks
:::OFFICIAL SNEAKER CARE/MAINTENANCE POST::: (It's back!)
- Thread in 'Jordan Brand' Thread starter Started by blazers21ntnp,
- Start date
Lol, no kidding, I already knew that, but these were given to me, so I figured I would do something with them! U have any ideas on that lace accent?
Thanks
- 4,203
- 1,418
Okay, just wanted to make sure you knew that so you didn't get scammed or something. The right way to fix that would be with grey angelus paint, but since thyre fake you could just use a grey sharpie if you don't want to spend the money on that
- 43
- 11
Hey, thanks for looking out bro, appreciate that! I think I'll get the paint, already tried the sharpie method n doesn't really look good
- 1,207
- 68
Maybe use this, I used this to restore my canvas sb dunk lows
I'm going to order that soon. But meantime I used soap and water with a brush and it gets the dirt off the bottom and low sides but ojt the too at all. Is it the material? How can I clean the top part. Homemade solutions would be better as I can do it now while I wait for the product to ship?
Updated pic
- 40
- 10
sucks to get a question ignored on here
- 5,813
- 3,970
What was your question?
- 3,640
- 1,946
You haven't asked anything...
- 9
- 10
Bump
- 3,229
- 2,001
Repainted my silver anniversary miid II. those soles chip and cracked twice as bad as III and IV.
I haven't copped a pair of II since
Last edited:
- 43
- 11
Thanks, I'll check it out!
- 9
- 10
Anyone???
- 4,203
- 1,418
what do you mean "clean" it? If it is dirty/muddy then use dish soap and water and scrub it with a brush. If you mean you want to unyellow it you have to use seaglow or retrobright.
- 2,924
- 914
same as any other shoe. they are going to oxidize no matter what.
- 39,295
- 40,725
real solid job on these.
my 4s have paint cracking but the nubuck looks clean enough for now.
just followed on ig
- 8,094
- 5,350
nah water and soap with a hard bristle toothbrush is fine after each wear but make sure you remove all of the water after cleaning or it might speed up the oxidation process
- 28
- 10
I'm about to start retrobrighting shoes indoors and was wondering what kind of lamp do some of you use, where do you get them from, and how much?
- 374
- 189
You can use regular daylight spectrum cfl bulbs. Can build a cheap setup with a 3-light vanity light, a pc power cord, & bulb splitters if you want more light. You can also use the setup to vegetate plants.
Last edited:
- 7
- 10
can someone help me with this crease on the side of the right shoe.. how would i get that out without damagin the tumble leather?
also
how would i get the part where the crease is sticking out by the bottom of the shoelaces right above the jordan tab. i have them on both shoes i dont know how to take that crap out
also
how would i get the part where the crease is sticking out by the bottom of the shoelaces right above the jordan tab. i have them on both shoes i dont know how to take that crap out
- 4,203
- 1,418
The only way to take that out without messing up the grain of the leather is to stuff them with bags or paper and try to push out the crease. If you iron it or Steam it will ruin it
can someone help me with this crease on the side of the right shoe.. how would i get that out without damagin the tumble leather?
also
how would i get the part where the crease is sticking out by the bottom of the shoelaces right above the jordan tab. i have them on both shoes i dont know how to take that crap out
- 16
- 11
Normally I don't get answered when i post here but I hope someone sees this and maybe has a solution for me... I noticed this little detail on my green glow 4s, must be some factory imperfection cause ive never seen 4s with this little issue, and googled/youtubed all i could imagine but found nothing like it... Could someone explain how exactly something like this happens and what could i do to at least attempt to fix it??
- 4,203
- 1,418
Is
is that glue? It's hard to tell in the picsNormally I don't get answered when i post here but I hope someone sees this and maybe has a solution for me... I noticed this little detail on my green glow 4s, must be some factory imperfection cause ive never seen 4s with this little issue, and googled/youtubed all i could imagine but found nothing like it... Could someone explain how exactly something like this happens and what could i do to at least attempt to fix it??
- 16
- 11
Its actually part of the midsole, and its like separated from the nubuck... Looks really weird, i wouldnt even know how to glue it back
- 10,240
- 2,966
That's such a miniscule imperfection, don't even worry about it. If it bothers you that much then sell em. It's really petty tho honestly.you'll never see that when on foot
- 1,207
- 68
Any help on my air maxes? How can I clean them to white again?
- 159
- 41
I been having trouble with angleus paint, and finishers. I been having the paint crack where the toe area creases. After trying it over 3 times it kept peeling with no luck. So i tried Angelus dye with a thin coat of finisher over it. The result? Cracking finisher . im sure it was prepped well. The toe area was bone white again after rubbing the black paint off to replace it with dye. . Im about to toss them. Any ideas? Maybe its because its synthetic leather and not real?
